Print Share
The following article is a general news item provided for the benefit of members. Its contents do not necessarily reflect the views of the Safety Institute of Australia.
Date: 
Wednesday, 28 November, 2018 - 12:45
Category: 
Incidents & prosecutions
Location: 
National News
Western Australia

WA’s Department of Mines, Industry Regulation and Safety is currently investigating an incident in which the operator of an elevating work platform was injured after his head became trapped.

In July 2018, an operator and a surveyor were in a mobile elevating work platform (EWP), taking survey measurements on a stacker structure to improve conveyor belt alignment.

They were working in close proximity to the underside of the stacker conveyor frame, located about 27 metres above the ground.

When the operator moved the EWP basket upward, his head became trapped between the stacker frame and the secondary guarding sensor bar in the basket.

The alarm at the EWP base alerted the spotter, who then proceeded to lower the basket.

The operator received injuries that had the potential to be serious, and he lost consciousness for a few minutes. Elevating work platform operator trapped against underside of conveyor structure.

The investigation found there were a number of contributing causes

  • The job hazard analysis (JHA) did not identify the hazard of being crushed against the stacker.
  • The EWP basket was directly below and in close proximity to the stacker conveyor frame.
  • The EWP operator activated the boom extend function instead of boom retract.
  • The EWP function speed control was set in fast mode (rabbit) instead of slow mode (tortoise).
  • Although activation of the secondary guarding sensor bar prevented further movement of the EWP basket, it did not retract the basket due to insufficient continuous pressure being applied.
  • There was a delay in bringing the basket to the ground, as the spotter was unaware of the boom operating envelope programmed into the EWP safety system.

WA’s Department of Mines, Industry Regulation and Safety subsequently issued a safety bulletin with a number of required actions:

  • Before undertaking work involving EWPs in the vicinity of fixed structures, ensure the potential hazard for workers to be crushed is identified, and effective controls implemented to prevent exposure to the hazard.
  • Ensure that the emergency plan for EWP work in restricted-access areas includes a suitable response to entrapment or entanglement within a structure.
  • Where there is a risk of crush injury to a person in an EWP from an overhead fixed object, use EWPs fitted with engineering controls such as protective cages and sensor devices.
  • Implement positive communication protocols between all personnel involved in the work.
  • Ensure all workers involved in the operation of an EWP have received adequate training and verification of competency for the equipment being used.